TMC E750 and E1000 Specs
Model/Size |
TMC 750 E-1 |
||||
A. INJECTION UNIT |
A | B | C | ||
| 1. Screw Diameter | in. | 3.74 | 3.94 | 4.33 | |
| 2. Screw Length to Dia. Ratio | L/D | 21 | 20 | 18.1 | |
| 3. Injection Pressure-Max | psi | 25411 | 23022 | 18955 | |
| 4. Injection Stroke | in. | 17.7 | 17.7 | 17.7 | |
| 5. Calculated Injection Volume | cu. in. | 194.5 | 215.6 | 260.8 | |
| 6. Injection Capacity (P.S.) | oz. | 103.5 | 114.6 | 138.7 | |
| 7. Plasticizing
Capacity* |
LS/HT | lb./hr. | 672 | 770 | 967 |
| HS/LT | lb./hr. | 1053 | 1209 | 1518 | |
| 8. Injection Rate at 1000 psi | cu. in./sec. | 31.85 | 35.27 | 42.65 | |
| 9. Standard
Screw Speed* |
LS/HT | rpm./ft.-lb. | 110/5830 | ||
| HS/LT | rpm./ft.-lb. | 160/4050 | |||
| 10. Back Pressure Adj. Range | psi | 0-1000 | |||
| 11. Nozzle Force | U.S. Ton | 13.8 | |||
| 12. Heating Input Power | kw. | 50 | |||
| 13. Barrel Heating Zones | No. | 4 + 1 | |||
B. CLAMPING UNIT |
|||||
| 14. Clamping Force | U.S. Ton | 825 | |||
| 15. Mold Opening Stroke | in. | 39.37 | |||
| 16. Open Daylight | in. | 78.74 | |||
| 17. Die-height Available | in. | 15.75 - 39.37 | |||
| 18. Sizes of Platens (H x W) | in. | 59.05 × 59.05 | |||
| 19. Space Between Tie-Bars | in. | 39.37 × 39.37 | |||
| 20. Ejector Force | U.S. Ton | 18.7 | |||
| 21. Ejector Stroke | in. | 9.45 | |||
C. GENERAL |
|||||
| 22. Pump Motor Power | kw. | 75 | |||
| 23. Hydraulic System Pressure | psi | 2000 | |||
| 24. Total Installed Power | kw. | 125 | |||
| 25.
Maximum Amp. Draw |
|
A | 543.5 | ||
|
|
A | 271.8 | |||
| 26. Oil Tank Capacity | G | 370 | |||
| 27. Hopper Capacity | lbs. | 265 | |||
| 28. Total Machine
Weights (approx.) |
lbs. | 88000 | |||
| 29.
Machine Dimensions (L×W×H) |
ft. | 32.8 × 6.5 × 9.6 | |||
