Model/Size |
TMC 500 E-1 |
||||
A. INJECTION UNIT |
A | B | C | ||
| 1. Screw Diameter | in. | 3.15 | 3.35 | 3.74 | |
| 2. Screw Length to Dia. Ratio | L/D | 21.2 | 20 | 17.8 | |
| 3. Injection Pressure-Max | psi | 27871 | 24686 | 19776 | |
| 4. Injection Stroke | in. | 15.7 | 15.7 | 15.7 | |
| 5. Calculated Injection Volume | cu. in. | 122.6 | 138.4 | 172.9 | |
| 6. Injection Capacity (P.S.) | oz. | 65.22 | 73.62 | 91.96 | |
| 7. Plasticizing
Capacity* |
LS/HT | lb./hr. | 457 | 529 | 699 |
| HS/LT | lb./hr. | 598 | 692 | 914 | |
| 8. Injection Rate at 1000 psi | cu. in./sec. | 22.15 | 24.95 | 31.24 | |
| 9. Standard
Screw Speed* |
LS/HT | rpm./ft.-lb. | 100/4810 | ||
| HS/LT | rpm./ft.-lb. | 150/3291 | |||
| 10. Back Pressure Adj. Range | psi | 0-1000 | |||
| 11. Nozzle Force | U.S. Ton | 10.6 | |||
| 12. Heating Input Power | kw. | 41 | |||
| 13. Barrel Heating Zones | No. | 4 + 1 | |||
B. CLAMPING UNIT |
|||||
| 14. Clamping Force | U.S. Ton | 550 | |||
| 15. Mold Opening Stroke | in. | 32.28 | |||
| 16. Open Daylight | in. | 67.71 | |||
| 17. Die-height Available | in. | 13.78 - 35.43 | |||
| 18. Sizes of Platens (H x W) | in. | 49.21 × 49.21 | |||
| 19. Space Between Tie-Bars | in. | 33.46 × 33.46 | |||
| 20. Ejector Force | U.S. Ton | 12.1 | |||
| 21. Ejector Stroke | in. | 7.87 | |||
C. GENERAL |
|||||
| 22. Pump Motor Power | kw. | 56 | |||
| 23. Hydraulic System Pressure | psi | 2000 | |||
| 24. Total Installed Power | kw. | 97 | |||
| 25.
Maximum Amp. Draw |
|
A | 421.8 | ||
|
|
A | 210.9 | |||
| 26. Oil Tank Capacity | G | 265 | |||
| 27. Hopper Capacity | lbs. | 200 | |||
| 28. Total Machine
Weights (approx.) |
lbs. | 55100 | |||
| 29. Machine Dimensions (L×W×H) |
ft. | 29.5 × 5.9 × 8.8 | |||
