Model/Size |
TMC 350 E-1 |
||||
A. INJECTION UNIT |
A | B | C | ||
| 1. Screw Diameter | in. | 2.76 | 2.95 | 3.15 | |
| 2. Screw Length to Dia. Ratio | L/D | 21.4 | 20 | 18.7 | |
| 3. Injection Pressure-Max | psi | 28440 | 24842 | 21828 | |
| 4. Injection Stroke | in. | 13.8 | 13.8 | 13.8 | |
| 5. Calculated Injection Volume | cu. in. | 82.12 | 94.26 | 107.26 | |
| 6. Injection Capacity (P.S.) | oz. | 43.70 | 50.44 | 57.07 | |
| 7. Plasticizing
Capacity* |
LS/HT | lb./hr. | 431 | 510 | 580 |
| HS/LT | lb./hr. | 509 | 603 | 686 | |
| 8. Injection Rate at 1000 psi | cu. in./sec. | 17.69 | 20.62 | 23.49 | |
| 9. Standard
Screw Speed* |
LS/HT | rpm./ft.-lb. | 165/2460 | ||
| HS/LT | rpm./ft.-lb. | 210/1917 | |||
| 10. Back Pressure Adj. Range | psi | 0-1000 | |||
| 11. Nozzle Force | U.S. Ton | 10.6 | |||
| 12. Heating Input Power | kw. | 32 | |||
| 13. Barrel Heating Zones | No. | 4 + 1 | |||
B. CLAMPING UNIT |
|||||
| 14. Clamping Force | U.S. Ton | 385 | |||
| 15. Mold Opening Stroke | in. | 25.2 | |||
| 16. Open Daylight | in. | 54.73 | |||
| 17. Die-height Available | in. | 11.8 - 29.53 | |||
| 18. Sizes of Platens (H x W) | in. | 41.34 × 41.34 | |||
| 19. Space Between Tie-Bars | in. | 27.95 × 27.95 | |||
| 20. Ejector Force | U.S. Ton | 9.9 | |||
| 21. Ejector Stroke | in. | 7.09 | |||
C. GENERAL |
|||||
| 22. Pump Motor Power | kw. | 45 | |||
| 23. Hydraulic System Pressure | psi | 2000 | |||
| 24. Total Installed Power | kw. | 77 | |||
| 25.
Maximum Amp. Draw |
|
A | 334.8 | ||
|
|
A | 167.4 | |||
| 26. Oil Tank Capacity | G | 210 | |||
| 27. Hopper Capacity | lbs. | 200 | |||
| 28. Total Machine
Weights (approx.) |
lbs. | 35300 | |||
| 29. Machine Dimensions (L×W×H) |
ft. | 24.9 × 5.4 × 8.2 | |||
