Model/Size |
TMC 250E |
||||
A. INJECTION UNIT |
A | B | C | ||
| 1. Screw Diameter | in. | 2.17 | 2.36 | 2.56 | |
| 2. Screw Length to Dia. Ratio | L/D | 21.8 | 20 | 18.4 | |
| 3. Injection Pressure-Max | psi | 28952 | 24330 | 20773 | |
| 4. Injection Stroke | in. | 11.8 | 11.8 | 11.8 | |
| 5. Calculated Injection Volume | cu. in. | 43.44 | 51.74 | 60.71 | |
| 6. Injection Capacity (P.S.) | oz. | 23.21 | 27.65 | 32.31 | |
| 7.
Plasticizing Capacity* |
LS/HT | lb./hr. | 223 | 272 | 328 |
| HS/LT | lb./hr. | 280 | 340 | 410 | |
| 8. Injection Rate at 1000 psi | cu. in./sec. | 11.17 | 13.30 | 15.62 | |
| 9. Standard
Screw Speed* |
LS/HT | rpm./ft.-lb. | 160/1649 | ||
| HS/LT | rpm./ft.-lb. | 200/1273 | |||
| 10. Back Pressure Adj. Range | psi | 0-1000 | |||
| 11. Nozzle Force | U.S. Ton | 6.6 | |||
| 12. Heating Input Power | kw. | 19 | |||
| 13. Barrel Heating Zones | No. | 3 + 1 | |||
B. CLAMPING UNIT |
|||||
| 14. Clamping Force | U.S. Ton | 275 | |||
| 15. Mold Opening Stroke | in. | 20 | |||
| 16. Open Daylight | in. | 43.62 | |||
| 17. Die-height Available | in. | 7.87 - 23.62 | |||
| 18. Sizes of Platens (H x W) | in. | 33.46 ×33.46 | |||
| 19. Space Between Tie-Bars | in. | 22.05 × 22.05 | |||
| 20. Ejector Force | U.S. Ton | 7.7 | |||
| 21. Ejector Stroke | in. | 5.51 | |||
C. GENERAL |
|||||
| 22. Pump Motor Power | kw. | 30 | |||
| 23. Hydraulic System Pressure | psi | 2000 | |||
| 24. Total Installed Power | kw. | 49 | |||
| 25.
Maximum Amp. Draw |
|
A | 213.1 | ||
|
|
A | 106.6 | |||
| 26. Oil Tank Capacity | G | 160 | |||
| 27. Hopper Capacity | lbs. | 150 | |||
| 28. Total Machine
Weights (approx.) |
lbs. | 22100 | |||
| 29. Machine Dimensions (L×W×H) |
ft. | 21.6 × 4.3 × 7.6 | |||
