Model/Size |
TMC 200 E-1 |
||||
A. INJECTION UNIT |
A | B | C | ||
| 1. Screw Diameter | in. | 1.97 | 2.17 | 2.36 | |
| 2. Screw Length to Dia. Ratio | L/D | 22 | 20 | 18.3 | |
| 3. Injection Pressure-Max | psi | 27729 | 22894 | 19268 | |
| 4. Injection Stroke | in. | 9.8 | 9.8 | 9.8 | |
| 5. Calculated Injection Volume | cu. in. | 29.96 | 36.24 | 43.14 | |
| 6. Injection Capacity (P.S.) | oz. | 15.91 | 19.26 | 22.22 | |
| 7.
Plasticizing Capacity* |
LS/HT | lb./hr. | 163 | 210 | 255 |
| HS/LT | lb./hr. | 217 | 280 | 340 | |
| 8. Injection Rate at 1000 psi | cu. in./sec. | 8.67 | 10.49 | 12.51 | |
| 9. Standard
Screw Speed* |
LS/HT | rpm./ft.-lb. | 150/1273 | ||
| HS/LT | rpm./ft.-lb. | 200/962 | |||
| 10. Back Pressure Adj. Range | psi | 0-1000 | |||
| 11. Nozzle Force | U.S. Ton | 6.6 | |||
| 12. Heating Input Power | kw. | 15 | |||
| 13. Barrel Heating Zones | No. | 3 + 1 | |||
B. CLAMPING UNIT |
|||||
| 14. Clamping Force | U.S. Ton | 220 | |||
| 15. Mold Opening Stroke | in. | 16.93 | |||
| 16. Open Daylight | in. | 35.58 | |||
| 17. Die-height Available | in. | 7.87 - 21.65 | |||
| 18. Sizes of Platens (H x W) | in. | 29.92 × 29.92 | |||
| 19. Space Between Tie-Bars | in. | 19.69 × 19.69 | |||
| 20. Ejector Force | U.S. Ton | 7.7 | |||
| 21. Ejector Stroke | in. | 4.72 | |||
C. GENERAL |
|||||
| 22. Pump Motor Power | kw. | 22.5 | |||
| 23. Hydraulic System Pressure | psi | 2000 | |||
| 24. Total Installed Power | kw. | 37 | |||
| 25.
Maximum Amp. Draw |
|
A | 160.9 | ||
|
|
A | 80.5 | |||
| 26. Oil Tank Capacity | G | 130 | |||
| 27. Hopper Capacity | lbs. | 150 | |||
| 28. Total Machine
Weights (approx.) |
lbs. | 17700 | |||
| 29. Machine Dimensions (L×W×H) |
ft. | 20.3 × 4.1 × 7.5 | |||
