Model/Size |
TMC 120 E1 |
||||
A. INJECTION UNIT |
A | B | C | ||
| 1. Screw Diameter | in. | 1.38 | 1.58 | 1.77 | |
| 2. Screw Length to Dia. Ratio | L/D | 22.8 | 20 | 17.7 | |
| 3. Injection Pressure-Max | psi | 31170 | 23989 | 18870 | |
| 4. Injection Stroke | in. | 7.1 | 7.1 | 7.1 | |
| 5. Calculated Injection Volume | cu. in. | 10.56 | 13.79 | 17.45 | |
| 6. Injection Capacity (P.S.) | oz. | 5.64 | 7.37 | 9.31 | |
| 7.
Plasticizing Capacity* |
LS/HT | lb./hr. | 84 | 114 | 159 |
| HS/LT | lb./hr. | 110 | 150 | 209 | |
| 8. Injection Rate at 1000 psi | cu. in./sec. | 4.88 | 6.35 | 8.06 | |
| 9.
Standard Screw Speed* |
LS/HT | rpm./ft.-lb. | 180/687 | ||
| HS/LT | rpm./ft.-lb. | 250/484 | |||
| 10. Back Pressure Adj. Range | psi | 0-1000 | |||
| 11. Nozzle Force | U.S. Ton | 6.6 | |||
| 12. Heating Input Power | kw. | 8.2 | |||
| 13. Barrel Heating Zones | No. | 3 + 1 | |||
B. CLAMPING UNIT |
|||||
| 14. Clamping Force | U.S. Ton | 132 | |||
| 15. Mold Opening Stroke | in. | 13.78 | |||
| 16. Open Daylight | in. | 30.51 | |||
| 17. Die-height Available | in. | 5.91 - 16.73 | |||
| 18. Sizes of Platens (H x W) | in. | 25.2 × 25.2 | |||
| 19. Space Between Tie-Bars | in. | 16.73 × 16.73 | |||
| 20. Ejector Force | U.S. Ton | 4.8 | |||
| 21. Ejector Stroke | in. | 3.94 | |||
C. GENERAL |
|||||
| 22. Pump Motor Power | kw. | 15 | |||
| 23. Hydraulic System Pressure | psi | 2000 | |||
| 24. Total Installed Power | kw. | 23 | |||
| 25.
Maximum Amp. Draw |
|
A | 100 | ||
|
|
A | 50 | |||
| 26. Oil Tank Capacity | G | 80 | |||
| 27. Hopper Capacity | lbs. | 80 | |||
| 28. Total Machine
Weights (approx.) |
lbs. | 11500 | |||
| 29. Machine Dimensions (L×W×H) |
ft. | 16.7 × 3.9 × 6.7 | |||
